TELE VUE SCIENTIFIC PART 3
+ New Product Announcement!

On the left is a Tele Vue 4x Powermate as part of a speckle interferometry system (Figure 6, Genet et al., 2014). Light curve of eclipsing binary on right (Moschner et al., 2021) included data taken with Tele Vue-102.

In this installment, we travel to Kitt Peak in the Arizona-Sonoran Desert to “speckle” binary stars and finally learn what the impressive-sounding Bundesdeutsche Arbeitsgemeinschaft für Veränderliche Sterne group does! (If you missed our prior Tele Vue Scientific installments, you can click to read Part 1 and Part 2).

4x Powermate and Speckle Imaging at Kitt Peak
Wide shot of the speckle interferometry system installed on the 2.1-meter scope at Kitt Peak. A Tele Vue 4x Powermate is the black vertical tube hanging off the bottom of the scope. (Figure 2, Genet et al., 2014).

Introduction Often practiced by amateur astronomers doing planetary work, “lucky”  imaging was invented by professional astronomers to try to “freeze” distortion of starlight passing through our planet’s turbulent atmosphere. This is done by taking many short exposures of a target, instead of one long one. Amateurs usually align and stack the best quality photos to create an image. Professionals use their data to perform speckle interferometry involving complex math. Speckle interferometry is useful in refining the orbits of close binary stars. The introduction to a 2014 paper, “Kitt Peak Speckle Interferometry of Close Visual Binary Stars,” explains how this works.

The resolutions of conventional visual binary observations were seeing limited until Labeyrie (1970) devised speckle interferometry as a way to circumvent seeing limitations and realize the full diffraction-limited resolution of a telescope. The light from a close binary passing through small cells in the atmosphere produces multiple binary star images which, if observed at high enough magnification with short exposures (typically 10 to 30 milliseconds), will “freeze” out the atmospheric turbulence and thus overcome seeing-limitations. Although the multiple double star images are randomly scattered throughout the image (often superimposed), their separation and position angle remains constant, allowing these two parameters to be extracted via Fourier analysis (autocorrelation).

The paper says that this technique, made practical with the introduction of the CCD camera, resulted in an order of magnitude improvement in binary star data measurement over visual observations. Speckle interferometry then became the preferred technique for characterizing close binary stars.

Continue reading “TELE VUE SCIENTIFIC PART 3
+ New Product Announcement!”